Radbody Piranha clips and bumper for OBRC OBZ
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Bumpers and clips for the Radbody Piranha body for the OBRC OBZ 1:28 car
- Rating
- 0 / 5
- Likes
- 0
- Downloads
- 27
- Makes
- 0
- Views
- 119
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- RC & Robotics
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
I made a front bumper and sideclips for the Radbody Piranha hardbody specifically for the OBRC OBZ 1:28 car.
The set comes with 2 front lips, one high, one low, and 3 sets of side clips: high, low and very low. The parts are marked with dots: 1 dot is high, 2 dots is low, 3 dots is very low.
I would normally expect to use either the high or low set together, but by all means experiment. I also included a 3mf file which includes the printer settinsg I used. Used PLA+ filament with a 0.2 nozzle. I haven't tested this with a 0.4 nozzle but it should work.
Needed to mount the lips to the bumper are 2 M2x10 flathead screws, 2 M2 washers and 2 M2 nuts.