1 / 3
Mini Arrow RC Wing - FC Box, VTX Holder, and Antenna Grommets — zdjęcie 1
1 / 3

Mini Arrow RC Wing - FC Box, VTX Holder, and Antenna Grommets

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Support advanced building structures for the Flite Test Mighty Mini Arrow RC Wing.

Ocena
0 / 5
Polubienia
1
Pobrania
6
Wydruki
0
Wyświetlenia
109
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
RC & Robotics
Licencja
Creative Commons — Attribution — Noncommercial

I built the attached files to fit most FPV plane parts inside the Mighty Mini Arrow from Flite Test (not an easy task with limited space). 

  • All parts were printed in Overture ASA with a box temp around 36-40C.

The box will hold the Mateksys F405 Wing v2 FC. If you use this, you will have to cut the center walls on the center Arrow housing foam (better if you do this as you build your plane instead of afterwards). 

The lid to the box was designed to hold the AKK Race Ranger VTX and has a wire shroud to protect the thin wires. You will need a 90 deg pigtail adapter for the antenna. To install the VTX, you will need heat embedded 3mm x 4 mm screw holds. I have a version of plain lid that doesn't mount the VTX, which I will upload later. 

  • I found printing this vertically on an edge with organic supports worked the best

The VTX antenna grommet prevents the lollipop antenna from damaging the foam wing during flight or general handling. 

Installation is pretty straight forward but let me know if you have questions. 

Tagi