1 / 3
40mm Challenge coin laser jig
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Jig for my laser engraver to hold a 40mm coin
- Ocena
- 0 / 5
- Polubienia
- 8
- Pobrania
- 38
- Wydruki
- 0
- Wyświetlenia
- 114
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Tools
- Licencja
- Creative Commons — Attribution — Noncommercial
This is a laser engraving jig for 40mm challenge coins.
Includes cut out for easier removal.
Gives a nice tight fit for the coin for me. Obviously there are a million different sources for these coins so I cannot guarantee your 40mm coin is the same as my 40mm coin ;)
My laser is a Commarker B4. The hole spacing is 25mm so if you have a different laser but the spacing is the same then this will mount correctly for you.
Holes are quite tight to start with but just run a screw through them a couple of times or bore them out to suit your needs