1 / 4
Boot and Glove dryer for a 4x10 Floor register — zdjęcie 1
1 / 4

Boot and Glove dryer for a 4x10 Floor register

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Using your home forces air heating register you can dry your boots and gloves.

Ocena
0 / 5
Polubienia
3
Pobrania
19
Wydruki
0
Wyświetlenia
205
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Winter Sports
Licencja
Creative Commons — Attribution

This will temporarily replace your 4x10 floor register.
To save on material and time as well for added strengths I used 1.5" ABS from Home Depot. 
The glove sections use 12" of 1.5" ABS pipe and the boot sections use 8" of 1.5" ABS pipe.
I made the glove sections higher as to not interfere with the boot soles. You can cut as needed depending on your gear. 

I feel PETG is best for this project. Also best to prep the print plate with glue stick. 

Note: The boot piece needs to be glued together. 
Note: I am told some 4x10 floor registers holes can be tight if they were not cut properly.

Tagi