Boot and Glove dryer for a 4x10 Floor register
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Using your home forces air heating register you can dry your boots and gloves.
- Rating
- 0 / 5
- Likes
- 3
- Downloads
- 20
- Makes
- 0
- Views
- 209
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Winter Sports
- License
- Creative Commons — Attribution
This will temporarily replace your 4x10 floor register.
To save on material and time as well for added strengths I used 1.5" ABS from Home Depot.
The glove sections use 12" of 1.5" ABS pipe and the boot sections use 8" of 1.5" ABS pipe.
I made the glove sections higher as to not interfere with the boot soles. You can cut as needed depending on your gear.
I feel PETG is best for this project. Also best to prep the print plate with glue stick.
Note: The boot piece needs to be glued together.
Note: I am told some 4x10 floor registers holes can be tight if they were not cut properly.
