Dragon Burner Nozzle Cam/Camera/Endoscope
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Holder for a 8.5mm endoscope cam for the Dragonburner.
- Ocena
- 0 / 5
- Polubienia
- 13
- Pobrania
- 27
- Wydruki
- 0
- Wyświetlenia
- 426
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Voron Parts & Upgrades
- Licencja
- GNU General Public License v3.0
Notes:
This model of the endoscope cam takes 3.3V! I also only used the 4 usb connections of the camera Module. I connected GND, D+,D- to the Pi and the 3.3v comes of a step down module.
You need at least 8mm free space in front of the DragonBurner. This is about the width of the cam holder.
Neo Pixel Leds are attached using Epoxy.
You need to run USB cable directly to the PI, as CAN-BUS does not appear to support USB.
BOM:
1MP USB endoscope module diameter 8.5mm FOV88 IP67 waterproof industrial steering endoscope (Ali)
Neo Pixel (Ali)
2x M3x8mm SHSC for securing cam from the sides
2x M3x 6-4mm SHSC for connecting cam holder to cowl
4x Voron Brass Heatset Insert (2 on the side and 2 at the back of the cam holder)
a bunch of thin wires (I dismanteled a Lan Cable to get some.)
Step-Down Module to give the camera 3.3V (May also use other source)