1 / 1
Voron M4 90T Gear for 200mm Belt — zdjęcie 1

Voron M4 90T Gear for 200mm Belt

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

90T Gear for the Voron M4 extruder, just in case that 80T gear doesn't create enough torque

Ocena
4 / 5
Polubienia
3
Pobrania
11
Wydruki
1
Wyświetlenia
151
Oceny
1

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Share Alike

Assembly

This part is assembled the same as the stock Voron M4 extruder, so the same installation steps can be followed. The belt is a bit tight to get on, but if you put the belt over both pulleys and slide them both on at the same time, it becomes a bit easier.

Extruder Tuning

Here's a good guide for printer extrusion tuning: Ellis' Print Tuning Guide

If you are using Klipper, you can set rotation_distance under [extruder] to the following equation:
stepper degrees (200 for 1.8, 400 for 0.9) * microsteps / steps per mm


ex. 200 * 16 / 627.5 = ~5.1
I found that ~627.5 worked for me, so I would start around 630 and adjust from there

Edits

Edit 6/26/25: Removed the counter-bore that made the GT2 pulley sit too far inward, this also removed the need for the 5 m3x8 button head screws.

Edit 5/25/25: Reduced total width by 1mm and reduced belt retention flange diameter by 2mm to reduce rubbing

This project was created with OnShape!

https://cad.onshape.com/documents/e390f69fdf4d817c602db322/w/b558496c0789d7138cdfcbb4/e/43226861fa43da6ea192b698?renderMode=0&uiState=6771603918cbdd7fb28bf691

Tagi