Razer Barracuda X and Xbox Controller Combo stand
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This model is used for keeping the Razer Barracuda X headphone and the Xbox controller displayed and stored on a stand
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 13
- Wydruki
- 0
- Wyświetlenia
- 128
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Organizers
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Credit to
and
for their models used in this model's creation.
OTHER HARDWARE NEEDED:
1x M3 (10mm) screw and a small pilot hole made by a drill using the speed mode for attaching the headphone holder.
Super Glue for connecting all the parts together, and when doing so, let it sit for a few minutes with around 10 lbs. of weight pushing it down.
Sandpaper ~220 grit for sanding of support interfaces on Headphone holder or anywhere else issues are caused
Print Settings:
For supports, use tree, as other styles use un-necessary filament.
For infill, use gyroid with 10% infill
Notes:
If needed, change the size of the joint module if your printer needs a slightly different size in order for the model to work.