1 / 3
Pālā — zdjęcie 1
1 / 3

Pālā

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

A Hadley (metric) - mounted phone holder for AstroHopper-guided star hopping

Ocena
0 / 5
Polubienia
1
Pobrania
25
Wydruki
0
Wyświetlenia
174
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Share Alike

Introduction

Pālā (Pāḷi: guardian, keeper) is a 3D-printed phone holder designed for the Hadley (metric) telescope. It mounts directly onto the Hadley’s dual dovetail holder and securely holds a mobile phone for use with AstroHopper (links to my fork of the original) and other manual star-hopping or telescope alignment apps.

I could not find an existing phone mount that fit the Hadley metric dovetail properly, so this model was designed from scratch to provide a rigid, vibration-free mounting solution. Pālā keeps the phone aligned with the telescope, allowing smooth sky navigation by physically moving the telescope rather than relying on electronics or motors.

The design uses standard metric hardware, much of which is commonly left over from a Hadley metric build. Screenshots of the assembled model and recommended print orientations are included.

Printing Instructions

  • Layer height: 0.2 mm

  • Material: PETG recommended (PLA should also work)

  • Walls: 3

  • Infill: 20% or higher

  • Supports: Not required

BOM

Part

Quantity

M4x50 Hex Bolt

1

M4x12 SHCS Screw

2

M4 Nut

3

Assembly

Note: The video does not show the knob.stl on the M4x50 hex bolt, but it should be obvious how it fits.

Tagi