1 / 7
Turbo Manifold - R53 Mini Cooper - for Borg Warner EFR B1-G turbocharger — zdjęcie 1
1 / 7

Turbo Manifold - R53 Mini Cooper - for Borg Warner EFR B1-G turbocharger

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Turbo header for an R53 mini cooper. T4 divided housing. Designed for use with a Borg Warner EFR-6258 turbocharger.

Ocena
0 / 5
Polubienia
6
Pobrania
97
Wydruki
0
Wyświetlenia
785
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Automotive
Licencja
Creative Commons — Attribution

turbo manifold concept for a Borg Warner EFR 6258 to be used on an R53 mini cooper. 
This design prioritizes short runner length and keeping the turbo deep in the engine bay. 
Sized to retain factory AC lines. 
Many other modifications will need to be made to the car. 
Includes holes to be tapped for 1/8" NPT for EGT probes (or will need to be plugged or filled in before printing) 

T4 flange holes are at the tap diameter for M10x1.5

Must be used with the factory bolts (they are a narrow flange head. Commercial flange heads will not fit!!!!) 

Desgined for use with a head ported out to the factory gasket dimension. 

test printed in PET-GF10 (pla supports) for mockup. 
Designed for powder bed 316SS printing. 

Suggest having it coated in Swaintech White Lightning or equivalent or doing some other form of heat shielding. Factory heat shield location is available, but might be slightly obscured. 
The two center bolts will likely need to be installed before lowering the header into position. 
Turbo can be mounted after header installed. (including the stud under the turbine exit, which needs to be pre-installed)

I left no provisions for locking that stud in place I suggest using one with an allen drive and putting the allen into the hole for back side access should it be required. 

Pardon the "layer shift" looking defect in the test print I made. Printer lost power and I had to slice the G-code and guess the start layer to resume and save the print. Lost about 0.8mm somewhere in there. 

Test print was done with a 0.8mm diamondback nozzle on a prusa XL using PET-GF10 from Fiberon

Tagi