HSW Multimeter Holder v2 - "Always Ready" Remix (Cables Stay Plugged In)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A remix of multimeter holder for the HSW, adding a cutout at the bottom so probes can remain plugged in while docked.
- Ocena
- 5 / 5
- Polubienia
- 14
- Pobrania
- 94
- Wydruki
- 1
- Wyświetlenia
- 294
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution — Noncommercial
This is a remix of the excellent "Multimeter holder for HSW" by Kudeiro.
While the original model fits the multimeter perfectly, I found it inconvenient to have to unplug the probes from the bottom ports every time I wanted to dock the meter on the wall or put it upside down.
Changes made in this remix:
Mirrored Probes Holder: I have moved the probes holder to the left side, so you can keep the cables plugged in via cutout and wrapped around for a neater look.
Cable Cutout: I have added a cutout in the bottom right corner. This allows the banana plugs of your probes to remain inserted into the multimeter while it sits flush in the holder.
Fixed Orientation: The model is pre-oriented in the optimal position for printing (standing upright), requiring no supports.
Fits standard cheap multimeters often found online (like the yellow one pictured in the original design).
Print Settings (Suggestions based on your slicer image):
Material: PLA or PETG (PETG is usually better for workshop environments, but PLA works fine).
Nozzle: 0.4mm standard.
Layer Height: 0.2mm typically works well for HSW parts.
Infill: 15% - 20% Gyroid or Cubic is sufficient for strength.
Supports: None needed with the new orientation.
Brim: Optional. If you have bed adhesion issues with tall, thin prints, use a small brim.
Happy printing! Share your makes with me below.