1 / 1
Wiggle-Woggles for lead screw guides for all Rat Rig V-Core 3, 3.1, 3.1 Hybrid and 3.2H printers — zdjęcie 1

Wiggle-Woggles for lead screw guides for all Rat Rig V-Core 3, 3.1, 3.1 Hybrid and 3.2H printers

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

These are cheaper and quieter than using bearings.

Ocena
0 / 5
Polubienia
8
Pobrania
31
Wydruki
0
Wyświetlenia
215
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Share Alike

These are a two part printable design consisting of the holder and a printable Wiggle-Woggle.
The design style of this Wiggle-Woggle holder is based on the leadscrew constraints Rat Rig introduced on the V-Core 3.1 These were no doubt inspired by the lead screw guides I introduced when I first introduced de-coupling tbed arms on the early V-Core 3 printers with Wobble rings and VenterMechs. Later Rat Rig adopted Oldham de-couplers to do the same job.

Use the Rear central leadscrew guide for a V-Core 3.1

Use the Rear offset leadscrew guide for a V-Core 3

The front guides are compatible with both the V-Core 3 and 3.1

I prefer leadscrew guides to leadscrew constraints. With the introduction of my VenterMech leadscrew decouplers and the subsequent release of Rat Rigs Oldham decouplers (which essentially do the same job) there is less risk of over constraining the leadscrews by restraining them at both the top and bottom.

However longterm use of Wiggle-woggle leadscrew guides by many users had previously demonstrated they were a non wearing item and were perfectly quiet in operation. Hence I still use them and recommend their use on V-Core 3.1  and all later variations V-Core 3 printers.

TPU Wiggle-Woggles - print from 85A or 95A TPU.These should be printed with a 0.4 mm nozzle and 0.2 mm layer height.

For faster printing the holders can be printed with a 0.6 mm nozzle and 0.3 mm layer height.

Coffee fund
If decide to make a donation to my coffee fund (which keeps me up late at night doing more of this stuff) I would appreciate it. There is absolutely no obligation for you to do this. My PayPal account is [email protected]

Please remember to post feed back as it is always valuable to me for future iterations.

Many thanks.
Liam Venter
MFBS Design

Tagi