Toyota Bonnet Release Lever Cable Clip
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A clip that attaches the bonnet release cable to the bonnet release lever on a 2004 Toyota Land Cruiser Prado 120 (J120)
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 38
- Wydruki
- 1
- Wyświetlenia
- 180
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Automotive
- Licencja
- Creative Commons — Attribution
The bonnet/hood release lever became detached from the bonnet release cable on my 120 Land Cruiser Prado (2004). While you could use some strong tape to keep it together, if the cable slips slightly out of position from the release lever, the bonnet/hood will no longer open.
This print is modeled after the original part (which broke on my vehicle). While this has only been tested on my specific vehicle, I suspect this could work for other Toyota models (and potentially other vehicles).
Print Settings
Printed with PETG (ABS/ASA/Nylon/(insert other heat-resistant filament here) should work fine, just don't use PLA
0.1mm layer height
0.4mm layer width
4x perimeter walls
brim enabled (although you could probably print without a brim)
supports enabled (depending on your printer and filament you may be able to get away without supports)
I used the 0.1mm DETAIL preset for my mk3s in PrusaSlicer with the brim, supports, and perimeter walls adjusted.
Instructions
With your bonnet/hood open and the release cable detached from the release lever:
Slide into the bonnet release cable with the plug portion facing out
Snap the u-shaped clip portion onto the release cable
Push the plug portion into the bonnet release lever
Test the fit and stability by pulling the release lever multiple times before closing the bonnet/hood
Enjoy!
BoM (Bill of Materials)
n/a, just the single printed part is required