1 / 2
CO2 sensor enclosure for ESP32 and SDC40
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Remixed this very nice box to fit an ESP32 development board and the SDC40.
- Ocena
- 0 / 5
- Polubienia
- 4
- Pobrania
- 30
- Wydruki
- 0
- Wyświetlenia
- 266
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution
I really liked the box, but the ESP32 I had laying around didn't have any holes for screws. It also came with all of the pins mounted, and I didn't want to remove them.
So I put in a "shelf" that the ESP32 snuggly straddles leaving enough space for the cables on the pins needed.
The SDC40 board can be fixed with M2 screws, but it's not really needed.
Lid is also fixed with the same type om M2 or 2mm self-tapping screws. I use the latter.
Has 3 holes in the bottom for wall mounting.