Zuru Xshot Insanity Rail Clip and Ammo Can
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Models for rail mounting an ammo can to the side of your Zuru Xshot Insanity Minigun.
- Ocena
- 0 / 5
- Polubienia
- 27
- Pobrania
- 176
- Wydruki
- 0
- Wyświetlenia
- 873
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Toys & Games
- Licencja
- Open Community License v1
I've created two separate models that - put together - will allow you to mount an ammo 'can' to the rails of your Zuru Xshot Insanity Minigun.
For both parts, I used 10% infill and an adaptive cubic pattern. I also only used 2 wall loops, but the ammo can probably would have benefitted from a higher wall loop count.
Rail Clip
This fits on to the orange mounting rails of the minigun. The mounting mechanism should work for the other orange mounting rails (there's one on both sides), but this specific variant was built to work with this ammo can. You can print it without supports if you position it properly on your build plate. (OrcaSlicer had no problems doing this.)
Amm Can
As stated on the tin, this is an ammo 'can' for storing the unfired rounds/belt. Keeps the belt out of the way of your legs when moving and looks cool! The ammo can is detachable from the Rail Clip by the use of a dovetail joint. Printing it used around 190g of material, inclusive of a support I included for the dovetail.