1 / 4
Empoli Glass Genie Bottle Stopper Thingy — zdjęcie 1
1 / 4

Empoli Glass Genie Bottle Stopper Thingy

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

This is a replacement gusset (plug/cork/stopper) for an Empoli style glass genie bottle.

Ocena
0 / 5
Polubienia
0
Pobrania
14
Wydruki
1
Wyświetlenia
159
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Home Decor
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

I inherited two Empoli glass "genie" bottles and bought a third recently. The plastic plugs that came with the bottles originally have all warped over time. I did some hunting and was not able to find a replacement available to purchase, so I decided to make my own. (Please see the warning below.)

I did my design a bit differently, since the original plug is not really printable and I can't do TPU supports. The top "petals" of the plug are meant to act as a washer to keep the upper and lower glass from clanking together. You might want to cut the notches out to help it flex.

I printed this with an old spool of Inland eFlex TPU which seems to be a softer Shore hardness, but it's not marked on the spool. I tried using some colored TPU that is a bit firmer, but the plugs did not sit properly. Your success may depend on the firmness of the material. I would suggest starting with the least infill (10%) and increase it if the fit is still too loose.

WARNING: The old plugs are difficult to remove. You will probably need to cut them out to remove them; they would not budge from any of my stoppers. Be EXTREMELY careful if you do cut it out. I carefully used the small flush cutters that came with my printer, and I still managed to chip some of the glass. If you have access to a hot knife and adequate ventilation, I would suggest that approach instead.

While you have the bottle plug removed, this is a good opportunity to carefully clean the inside of the stopper and get rid of any old mineral buildup or dust.

I originally wanted to do this in OpenSCAD, but I got a case of the lazies and used something else. You can see most of my design iterations in the last photo. If there is interest from anyone for a version with adjustable tolerances, I would be willing to still make a customizable parametric model in OpenSCAD.

Edit: another user was kind enough to tell me the proper name for this thingy. It is called a "gusset" FYI!

Tagi