Traxxas Rally - DJI Air Unit - FPV Mounting Kit
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
DJI Air Unit + Traxxas Rally - FPV solution for mounting, cooling and powering the Air Unit
- Ocena
- 0 / 5
- Polubienia
- 14
- Pobrania
- 64
- Wydruki
- 0
- Wyświetlenia
- 1099
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- RC & Robotics
- Licencja
- Creative Commons — Attribution — Noncommercial
This is a full DJI Air Unit + Traxxas Rally FPV solution for mounting, cooling and powering the Air Unit within the Traxxas Rally shell.
You'll need:
1 x 40mm fan (10mm thick)
2 x M3 12mm (to hold the fans)
2 x M3 nuts (to hold the fan screws)
1 x M2 10/15mm (for the center hold-down)
3 x M3 12mm (10mm also) (roof & front-door)
2 x M3 12mm (10mm also) (antenna support/holder)
6 x M3 45mm socket head (roof mount and antenna mount)
10 x M3 nuts (stand-offs for the roof, main body and antenna holder)
2 x M3 washers (supports the antenna holder holes)
6 x M3 lock nuts (4 minimum)
You'll need supports for the the 3S Battery holder and the Case - Front parts. Everything else should be support free. The orientation should be correct when you open the files. The Air Unit is a tight fit, though no sanding should be needed. Make sure you get your fan wire out the back (under the air unit) before putting the front door on.