1:3 Scale Federal Signal Model 7T
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is an exact 1:3 scale replica. I own a real Model 7T and got all the measurements from it.
- Ocena
- 0 / 5
- Polubienia
- 17
- Pobrania
- 157
- Wydruki
- 1
- Wyświetlenia
- 760
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
The motor body and endbell are secured using the original screws that come with the motor.
Motor is a Samsung DE31-00029H. You can also use a DE31-00029K or DE31-00029J or any other 29 motor.
There are two motor body variants. The "normal shaft" variant has a hole for the motor's rear shaft to pass through so you don't have to cut it. The "cut shaft" variant is closed off like the real one, but you need to cut the rear shaft short in order to fit that.
If you don't cut the shaft, you will need the desktop stand printed in order to set it down.
Housing has the top hat screwed to the top body and bottom skirt plastic welded to the main body. If printed in fourths, the hat and bottom skirt both need plastic welded together. I suggest screwing the top hat to the body first before welding it together. The top body joins to the main body with screws. It is just slipped together on the real siren, but I added the screws on the mini for convenience.
M4x20mm machine screws (4x) (hold stator to the endbell)
M4x16mm machine screws (3x) (hold core to the stand)
M4x8mm machine screws (6x) (hold A frame to stator, and cosmetic detail on the endbell.)
M4 nut (10x)
M4 eyebolt (1x)
M3x10mm machine screws (2x) (cable clamp on the stand)
M3x6mm machine screws (4x) (securing junction box to the motor) Must be button head so the capacitor fits.
M3x5.7mm heat set threaded inserts (6x) (cable clamp on the stand and hold junction box to the motor)
https://www.amazon.com/gp/product/B081BCRZZS3
M2x8 machine screws (housing parts and junction box lid) (16x)
Button head for the housing parts, socket cap for the junction box lid.
Junction Box:
A very specific 8uf capacitor https://www.amazon.com/dp/B0143VJN40
Small wire nuts (2x)
Cable clamp connector with 1/2" knockout. Can pick these up super cheap at hardware stores like lowes or home depot.
Generic 120v cord. I use the Husky 16 gauge 8 foot cord that Home Depot has on the shelf for $11
Rotor installation:
8mm to 8mm 14mm OD 25mm L shaft coupler
10 gram slotted weights (16x)
https://www.amazon.com/dp/B0D2Q2QW43
To secure the weights, simply push them into the bottom of the rotor. They should just slip right in. If needed, you can tap them in with a hammer. These are made of steel, so it should be alright to take some hammer taps.
Put a set screw in both top holes on the shaft coupler. leave the bottom two screw holes empty. Then tap the coupler into the rotor from the bottom with a plastic mallet or plastic screwdriver handle.
Make sure the set screws are lined up with the access cutouts in the rotor hub. Don't use a hammer, you can damage the soft aluminum.