9V PP3 Battery holder
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
9V PP3 Battery holder Source code: https://github.com/MrSVCD/9V_PP3_Battery_holder
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 10
- Wydruki
- 0
- Wyświetlenia
- 72
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution — Noncommercial — NoDerivatives
9V PP3 Battery holder
AGPL-3.0 source code: https://github.com/MrSVCD/9V_PP3_Battery_holder
Simple PP3 9v battery holder for when you need a some what high DC voltage or just hold some PP3s.
The stl models can easily be mirrored in you 3D slicer if you want to switch places of plus and minus to fit your projects needs.
I only made models for up to 6 PP3s since when I studying to be a electrician I was taught that anything above 60 volt is dangerous.
Assembly
Parts needed:
Printed holder.
2 M3x10 screws per battery
2 M3 washers per battery
1 paperclip per battery + 1 paperclip
Tools:
screwdriver
wire cutter
needle nose pliers
Unfold the paperclips, you might be able to reuse some bends.
Fold the paperclips so that they fit like this. Here I wanted a middle tap here so the middle one sticks out a bit. Screw the clips in place like the rightmost one.
After you have screwed them in place, it is time to cut them off about 14mm from the top edge so that they fit in the slot on the bottom but don't poke thru.
Battery mounting and removal
