AtomStack Kraft Riser
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Gadgets
- Licencja
- Creative Commons — Public Domain
Corner supports fit firm to machine. Corner supports have notches on top for double sided tape(heavy duty 0.07"thick) and on the sides for magnets(60mmx10mmx3-5mm). Panels may need to be adjust for your machine(mine wasn't square). I would use the cut tool in slicer to trim off extra length. Panels anlso include notches for the same magnets. I put vents on the right and front panels of mine to allow air to pull through/across via the vent fan. The panels have slightly more height to adjust for none slip pads on corner supports. Honeycomb supports are to raise the honeycomb to reach a workable height for thin material.
I printed with 4 walls, 5 top and 4 bottom for strength on corners supports. Panels are 3,4,3 respectively. Used the cut tool with dovetail in the slicer to fit the panels and join at thicker spots. This all uses about 2 spools of filament. About $50 for everything with filament, magnets, tape, pads.
Warning: Riser / Panels will expose laser.