Focusrite Scarlett 4i4 (4th Gen) LED light shield
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Simple snap-on visor to cover the bright front-facing LEDs on the Focusrite Scarlett 4i4 (4th Gen), for always-on setups
- Ocena
- 4 / 5
- Polubienia
- 2
- Pobrania
- 8
- Wydruki
- 1
- Wyświetlenia
- 159
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Audio
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Do you leave your audio interface powered on 24/7? If you have the Focusrite Scarlett 4i4 (4th Gen) in a bedroom or a dark studio, the standby lights and gain halos can be distracting.
I designed this low-profile cover to solve that problem. It slides over the top edge of the interface to shield your eyes from the LEDs without permanently modifying the hardware. It uses a friction fit to stay in place — no tape or glue required — and is designed to leave enough clearance so you can still adjust the gain knobs and volume controls comfortably.
Print Instructions
Material: PLA or PETG (Matte Black PLA is recommended for the best aesthetic match).
Layer Height: 0.2 mm.
Infill: 15%—20% (it is a small part, so infill doesn't matter much).
Supports: None
Brim: None
Installation instructions
Simply slide the cover over the top front edge of the interface. It should sit flush against the faceplate. To remove, just lift it off.