Upper door addon for AD5X enclosure with taller lid.
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Access door in place of the front upper window.
- Ocena
- 0 / 5
- Polubienia
- 41
- Pobrania
- 104
- Wydruki
- 0
- Wyświetlenia
- 1126
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
I added a door to the front upper window. The hinges are similar to the enclosure hinges, but not interchangeable; these ones use M4 screws since it is through just plastic. There is one hinge I placed the the print in place configuration off to one side.
The handle and D3 riser have spaces for 2 5mm x 2mm magnets in each of them. Make sure to get the orientation correct so they attract or the door won't close.
I also included a second design of the door handle which closes with the door flush with the riser. I had trouble getting the door to close as tightly as I wanted it to because the panel I cut was not perfect sized.
I placed a panel in the STL file with the holes in it. I used this to make jigs for the holes which seemed to work ok. I would recommend to either do that ore use the caliper feature in your slice to get the measurements for drilling the holes in the panel for the hinges and handle.
The door panel is 273mm x 132mm x 1/8 inch (3mm). I made all of my clear panels from Polycarbonate because I also added a chamber heating pad to one wall and a recirculation fan so I can print PCTG and ASA better.