1 / 4
1.5" Roll Cage Tube Mount For Baofeng TP5 — zdjęcie 1
1 / 4

1.5" Roll Cage Tube Mount For Baofeng TP5

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Mount your radio for race communications

Ocena
0 / 5
Polubienia
3
Pobrania
19
Wydruki
0
Wyświetlenia
89
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Automotive
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

Mount for Baofeng TP5 radio on a roll cage for racing communications.  Allows access to all buttons and the connector on the side.   Requires that the belt clip be installed, and you'll need to cut a piece of foam to sit in the bottom of the mount.  The stuff I used was about 1.75" thick.  You could probably use other stuff to serve the same purpose as long as the radio gets pushed up firmly against the belt clip.  I haven't actually used this in a race yet so can't provide experience there but it feels pretty snug.

I don't have the more common UV-5R to test, but that radio might also work with this mount, I think they are fairly similar size but no promises.  If there's a modification I can make to allow that to work, let me know happy to make a UV-5R version also if it doesn't fit.  I've included a test file that's smaller than the full mount (no roll cage attachment) if you want to test your radio fitup without wasting a lot of filament.

I used these heat set inserts (the M6 size), although you could also just drill it out and use a nut instead:

https://a.co/d/c4PAkFG

These are the screws I happened to have around but there's nothing special about them, use what you have:

https://a.co/d/biPAU3k