Skellet 40 Case
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Case for the Skellet 40 by Novel Keys/Yiancar Designs. This case uses the plate from the kit.
- Ocena
- 5 / 5
- Polubienia
- 3
- Pobrania
- 22
- Wydruki
- 1
- Wyświetlenia
- 120
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Gadgets
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Uses 4x M3 (16mm, I think?) screws and nuts, not heatset, just throughhole. I recommend a small tool (like another screwdriver or toothpick) to help settle the nuts into the long holes in the bottom to make it easy for the screw to catch the threads.
You can also lay thin (1mm?) "gasket" around the lip that the plate rests on. I used strips cut from an old bike tube, and glued it in place minimally with a glue stick (really just enough to hold it while you set the plate in place, once assembled the screws will hold it firmly.
Should be printable without supports:
Print the top case upside down.
Print the bottom case right side up. Using a layer height of 0.2, the holes for the M3 nuts use a layer bridging trick to avoid printing in midair and thus don't require support.