1 / 1
IKEA Skogsta Table Space Filler for the Whole table — zdjęcie 1

IKEA Skogsta Table Space Filler for the Whole table

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Changed the one piece to a few so that it could cover the entire table's length.

Ocena
0 / 5
Polubienia
1
Pobrania
10
Wydruki
0
Wyświetlenia
167
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Office
Licencja
Creative Commons — Attribution — Noncommercial

HermannSW was awesome for this idea and it inspired me to do some of my first modeling! I wanted to make this a somewhat permanent fixture at our table as I love this table, but hate the gap along the center and all the crud that can get in there. 

Its three files this time around so that we can use one to fill the final gap as well as have end pieces to lock it in from sliding off the edge of the table. I used Microcenter's Inland PLA+ Natural (basically just transparent) to create what is used in the picture uploaded here. If you go with a solid color, you could possibly tape the underside of it for even less movement if you have a particularly active table, but these won't move much as they are. 

Print count:

11 - Table Space Filler_No End Walls

1 - Table Space Filler_No End Walls SHORT

2 - Table Space Filler_End Piece

Print instructions:

No supports/brims. Default PLA profiles on your slicers will work just fine as not much here is thicker than a layer. Just plan to make a couple of extra "Table Space Filler_No End Walls" if your printer isn't fully dialed in and the single layer comes apart when you grab it from the print bed. Patience is the key here. It will mostly come off by itself if you just wait for the bed to fully cool off. Try to flex it off the plate rather than peel it off.

Things to note:

For the "Table Space Filler_End Piece", one side of the notch will be longer than the other. That side will be towards the inside of the table. The short end will sit more flush with the edge. You will slide the notch over the round fastener that holds the two table slabs together. This will make it so the pieces won't slide off.  You'll want to install these first so the rest of the pieces just slide in against it. 

For the "Table Space Filler_No End Walls SHORT", it is the last piece to add ideally along the center and will fill in the remaining gap. Feel free to lengthen or shorten this piece as needed. It is just the other piece again, but reduced down to 82.22% length of it as that is what was needed for my table. Another thought on this: If you are using a bigger printer and prefer symmetry, you could just do 10 of the other piece and add this percentage over to the 11th piece as the true center of your Skogsta.

This setup is intentionally made to have a very miniscule gap if you print it all as-is. As well as the end pieces having slight play to them. This is because wood will flex throughout the year and I did not want that to break or pop out the pieces. Feel free to adjust it to make it as airtight or loose as you'd like :)

This is my first upload on any STL site so please let me know if it helped at all! Thanks for checking this out and happy printing!

Tagi