1 / 5
MiniSumo Wheel (Economy Gearbox ) — zdjęcie 1
1 / 5

MiniSumo Wheel (Economy Gearbox )

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Designed to fit the "economy" or "low cost" plastic gear motors and is aimed at Mini-Sumo Robots.

Ocena
0 / 5
Polubienia
1
Pobrania
43
Wydruki
0
Wyświetlenia
387
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
RC & Robotics
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

These wheels are designed to fit the "economy" or "low cost" plastic gear motors and is aimed at Mini-Sumo and small robots with rubber band tyres.

Instructions

This wheel was designed on Creo Elements, and printed on a Printrbot Simple Metal using Repetier Host with Slicer.

These wheels are sized to fit #16 #31 or #72 rubbers bands with a 10% stretch.

It's pictured with the #16 but some double sided tape may be required to stop them sliding off side ways... there's not real slip in rotation. The wider bands are more stable and less likely to roll off the side if pushed by an opponent.

23Dec14 - Picture added for #31 red bands tyres, not so common a size in the UK but much better in performance. I'd not recommend #16 if you can help it as they're more prone to rolling off if lateral force is experience - a larger up lift on the rim may help.

The Printrbot equipment was made available by Tanghall Smart Tech Club in York, England.

Category: Robotics

Tagi