MiniSumo Wheel (Economy Gearbox )
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Designed to fit the "economy" or "low cost" plastic gear motors and is aimed at Mini-Sumo Robots.
- Rating
- 0 / 5
- Likes
- 1
- Downloads
- 43
- Makes
- 0
- Views
- 387
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- RC & Robotics
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
These wheels are designed to fit the "economy" or "low cost" plastic gear motors and is aimed at Mini-Sumo and small robots with rubber band tyres.
Instructions
This wheel was designed on Creo Elements, and printed on a Printrbot Simple Metal using Repetier Host with Slicer.
These wheels are sized to fit #16 #31 or #72 rubbers bands with a 10% stretch.
It's pictured with the #16 but some double sided tape may be required to stop them sliding off side ways... there's not real slip in rotation. The wider bands are more stable and less likely to roll off the side if pushed by an opponent.
23Dec14 - Picture added for #31 red bands tyres, not so common a size in the UK but much better in performance. I'd not recommend #16 if you can help it as they're more prone to rolling off if lateral force is experience - a larger up lift on the rim may help.
The Printrbot equipment was made available by Tanghall Smart Tech Club in York, England.
Category: Robotics