Pluto Wall Lamp for IKEA Smila Blomma Lamp (Lithophane)

I have generated a lithophane of the minor planet Pluto and adapted it for an IKEA Smila Blomma wall lamp.

This model should be relatively tolerant of choice of material but a thin/high quality layer size is recommended.  The pictured print was made using white PETG in 0.16 mm layers without supports on a Bambu P1S in just over 10 hours.

Notes:

1. IKEA has recalled earlier versions of these lamps as a strangulation hazard, so use them at your own discretion (https://www.cpsc.gov/Recalls/2013/ikea-recalls-childrens-wall-mounted-lamps)

2. This is made for the revised US version of the Smila Blomma lamp available circa 2015 which has a different mounting pattern than some other/older versions of the lamp.  Check the picture to make sure yours matches before printing.

3. The data available for the surface of Pluto is limited so the hemisphere modeled the most complete data available, but it is still incomplete, has parts that are low-resolution, and is not in a strict north-up orientation as is expected of models such as these.   I left the data unmodified so that it is scientifically accurate while working to get as much available information into the model as possible.  If you have a spacecraft visiting Pluto, please forward images and I will update the model.

Credits:

This model is inspired by the Moon wall lamp reusing Ikea Smila lamp found here: https://www.printables.com/model/223946-moon-wall-lamp-reusing-ikea-smila-lamp

The spherical lithophane was generated using the 3DSolarLithophane project which can be obtained here:  https://github.com/ratmole/3dSolarLithophane

Crediting myself, but you can get just the ring part of this project to make your own planetary lithophane here: https://www.printables.com/model/1561204-ikea-smila-blomma-adapter-ring