HEMA Rondel Dagger Silicone Mold
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a 30cm rondel dagger mold to use for HEMA. Can be printed in 256mm plates, needs some assembly and silicone.
- Ocena
- 0 / 5
- Polubienia
- 4
- Pobrania
- 15
- Wydruki
- 0
- Wyświetlenia
- 102
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Sports
- Licencja
- Creative Commons — Attribution
This is a 30cm rondel dagger, should be about same size as the Cold Steel one. I also shared the rondel as STL, if you don't want to fiddle with silicone... That wouldn't be safe, of course.
You print 2 of each mold pieces, assemble the halves with screws (4 M3x15 screws), there are alignment pins. Then after covering the innards with silicone release spray. Assemble the two halves with M3x40 screws.
Fill the gaps on the side with hot wax, or something equivalent. You may use some bathroom silicone for simplicity sake.
Place the mold upright. Then fill it up with silicone of your desired shore value.
For reference the Cold Steel is made out of PP, should be about 60-70 shore.
Vibrate/tap on the floor till the bubbles finish up, then set it up for curing.
Then separate the mold, you got yourself a cheap dagger.