1 / 1
Gale Force S Dust Blower Nozzles & Accessories (may fit others) — zdjęcie 1

Gale Force S Dust Blower Nozzles & Accessories (may fit others)

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Gale Force S dust blower accessories

Ocena
0 / 5
Polubienia
22
Pobrania
78
Wydruki
0
Wyświetlenia
739
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Other Gadgets
Licencja
Creative Commons — Attribution — Share Alike

Gale Force S blower nozzles and accessories.

This particular blower does not really allow for other nozzles as they clip on and the little clips are very weak so I made a set, then made some pimping up accessories. The units doesn't stand well so made a bottom for it and also the slider on the side was very small so made an upgrade for that (superglue this on).  These fit so snug they don't let any air escape, even the genuine one doesn't do that.

I did remix these nozzles from Emoticon on Makerworld 

The rest of it I made myself.

These could be easily resized to fit other blowers, the diameter of this blower's hexagonal body is 36.5mm - just drag the nozzles into tinkercad etc and resize them to suit - if yours for example is 37mm then just drag the nozzle out by 0.5mm on each side.

I printed them in PLA+ and they are fine, you could also use TPU etc. Support will be needed on the ring part, I couldn't print it up the other way, it kept coming off the bed and I didn't want to use a brim.

Tagi