Floating Filament Holder Using Recycled Prusament Spool Ends
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
I didn't want to just throw out the nice Pusament spool holders once they were finished so I designed this floating…
- Ocena
- 0 / 5
- Polubienia
- 3
- Pobrania
- 26
- Wydruki
- 0
- Wyświetlenia
- 676
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Accessories
- Licencja
- Creative Commons — Public Domain
I didn't want to just throw out the nice Pusament spool holders once they were finished so I designed this floating holder that accepts one end of the spool to create a nice aesthetic way to hold full rolls of new rolls and have them ready to load at a moment's notice! Simply print out the holder, then slide one end of a Prusament empty spool onto the back! It even has a little spline to prevent the end from spinning. You can see what this looks like mounted, mounted with an end, and mounted holding a filament spool in the first picture (I swear I didn't paint the walls to match it just worked out that way). Use a 2 inch plaster or wood screw to mount to the wall.
Print instructions
I used the stock settings in PrusaSlicer for PET, but any material will work. Make sure you set the Fill Density to 10% and the Fill Pattern to "Honeycomb" to match that nice design of the Prusament spool ends.
IMPORTANT: Set the top and bottom horizontal shells to 0, so that the honeycomb pattern actually shows (under Print Settings, Layers and perimeters, Horizontal shells, Solid Layers)