1 / 10
ULINE 5578 / 5579 (Akro-Mils) Plastic Parts Cabinet Drawer Dividers — zdjęcie 1
1 / 10

ULINE 5578 / 5579 (Akro-Mils) Plastic Parts Cabinet Drawer Dividers

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Lightweight yet strong printable dividers allowing up to 5 slots in a small drawer, or up to 10 slots in a large drawer

Ocena
0 / 5
Polubienia
4
Pobrania
10
Wydruki
0
Wyświetlenia
86
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Organizers
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

These are drawer dividers for Akro-Mils storage units (also Uline H-5578 and H-5579). There are variations to split a small drawer into 2 to 5 partitions, and a larger drawer into 2 to 10 partitions. The SolidWorks files and STEP files are included to allow for further customization. I'd recommend printing them out of PETG or PLA if used indoors, or ABS or another heat-resistant filament if used outdoors. The 3x1 and 5x1 small drawer dividers are a bit weaker due to the lack of a middle wall strengthening their inserts (see second to last picture).

Print Settings:

Layer Height: Any

Wall Count: 3

Print Orientation: See last photo

Support: Should only be needed with the No Rim Large Drawer Dividers. I recommend an 8mm-10mm brim for those, or some beefy mouse ears. The With Rim Large Drawer Dividers should get around this issue, at the cost of a bit more filament.

Note: The most important thing for these is good layer adhesion. If you find they are breaking along layer lines, try upping your printing temperature or slow down the printer.

Acknowledgements:

I heavily based my template design off of Daniel Stein's design found here https://www.thingiverse.com/thing:49439. A huge thank you to him for providing the .sldprt file, as I didn't have a divider I could pull measurements off of. For the large drawers, I took some measurements of the drawers and did a few iterations until I found the best fit. I believe that the draft angle of the drawers themselves is ~3 degrees, which I didn't account for in this design as the gap it produces is at the top of the divider, and is so small even M2 hardware won't slip through.

I also took heavy inspiration from clubniewski's design found here https://www.printables.com/model/880506-dividers-for-uline-plastic-part-cabinet. Specifically the way they designed the divider insert for their 3x1 small drawer holder. I used a slightly beefed up variation for my 3x1 and 5x1 small drawer dividers.

Tagi