ULINE 5578 / 5579 (Akro-Mils) Plastic Parts Cabinet Drawer Dividers
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Lightweight yet strong printable dividers allowing up to 5 slots in a small drawer, or up to 10 slots in a large drawer
- Rating
- 0 / 5
- Likes
- 4
- Downloads
- 10
- Makes
- 0
- Views
- 88
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Organizers
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
These are drawer dividers for Akro-Mils storage units (also Uline H-5578 and H-5579). There are variations to split a small drawer into 2 to 5 partitions, and a larger drawer into 2 to 10 partitions. The SolidWorks files and STEP files are included to allow for further customization. I'd recommend printing them out of PETG or PLA if used indoors, or ABS or another heat-resistant filament if used outdoors. The 3x1 and 5x1 small drawer dividers are a bit weaker due to the lack of a middle wall strengthening their inserts (see second to last picture).
Print Settings:
Layer Height: Any
Wall Count: 3
Print Orientation: See last photo
Support: Should only be needed with the No Rim Large Drawer Dividers. I recommend an 8mm-10mm brim for those, or some beefy mouse ears. The With Rim Large Drawer Dividers should get around this issue, at the cost of a bit more filament.
Note: The most important thing for these is good layer adhesion. If you find they are breaking along layer lines, try upping your printing temperature or slow down the printer.
Acknowledgements:
I heavily based my template design off of Daniel Stein's design found here https://www.thingiverse.com/thing:49439. A huge thank you to him for providing the .sldprt file, as I didn't have a divider I could pull measurements off of. For the large drawers, I took some measurements of the drawers and did a few iterations until I found the best fit. I believe that the draft angle of the drawers themselves is ~3 degrees, which I didn't account for in this design as the gap it produces is at the top of the divider, and is so small even M2 hardware won't slip through.
I also took heavy inspiration from clubniewski's design found here https://www.printables.com/model/880506-dividers-for-uline-plastic-part-cabinet. Specifically the way they designed the divider insert for their 3x1 small drawer holder. I used a slightly beefed up variation for my 3x1 and 5x1 small drawer dividers.
