Arrma 223S Shock Rod End (ARA330666)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Shock rod end fits most Arrma 223S and 3S model shocks.
- Ocena
- 0 / 5
- Polubienia
- 6
- Pobrania
- 42
- Wydruki
- 0
- Wyświetlenia
- 201
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- RC & Robotics
- Licencja
- Creative Commons — Attribution — Noncommercial
I created a replacement Arrma 223S Shock Rod End (ARA330666) for my 1/8 223S Typhon. Looks like this will fit most Arrma 223S and 3S models, but check website for compatibility. I had to modify the original design to be more additive friendly, which should not impact function. Print with flat side facing down. I printed in Prusament PC Blend, but PETG is probably ok as well. I would not recommend PLA. Additional print settings below.
***Update 4/17/2026. I had the threaded rod pull out of the 3D printed shock rod end on a hard landing. I reduced the hole diameter to get better thread engagement. No problems with the new design so far. Please ensure that you are using the V2 STL!
Supports: Support on Build Plate Only
Layer Height: .15mm Structural
Perimeters: 3