Frankenstein duct Bambu labs X1C hotend mount
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Mount to use a bare Bambu labs X1C hotend + V6 nozzle with the KevinAKASam Frankenstein Duct
- Ocena
- 0 / 5
- Polubienia
- 5
- Pobrania
- 16
- Wydruki
- 0
- Wyświetlenia
- 175
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- GNU General Public License v3.0
This is a hotend mount for the KevinAKASam Frankenstein Duct. This was specifically designed to allow the use of a cheap Bambu labs X1C (or P1P/S) style bare hotend rather than the more commonly recommended TZ V6 hotends. The base mount is configured for use with V6, rather than Bambu, nozzles, as that's what I intend to run on my machines for the most part, but I've included a standard mount cleat that lowers the hotend the required 2mm for use with Bambu nozzles.
You will need:
2 M3 Voron spec heatsets
2 M3x16 SHCS - Secures the hotend to the cleat
4 M2 Hetsets
4 M2X6 SHCS - Secures the cleat to the back bracket
A Bambu Labs X1C hotend (you can use P1P hotends too, only difference I've seen is the wire termination, which you will likely need to cut off anyway).
Print the Back, Front and the version of the cleat you intend to use (V6 or Std.). I used 5/5/5 Walls/Top/Bottom and 25% infill using ASA-CF, but regular ABS should work fine. I found that when using the M2 heatsets, I had to go in after setting with a small 1.5mm drill to clean out some of the plastic that had oozed into the bottom of the holes in order for the screws to seat flush.