1 / 6
AI-On-The-Edge / Watermeter housing for Zehner counter — zdjęcie 1
1 / 6

AI-On-The-Edge / Watermeter housing for Zehner counter

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

I made this housing as I had a lot problems with reflections in the camera picture.

Ocena
0 / 5
Polubienia
2
Pobrania
58
Wydruki
0
Wyświetlenia
335
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution

This is a housing for an ESP32-cam to use with the open source AI-on-the-edge watermeter solution.

I designed it as I had a lot problems with reflections in the camera picture.

The outer housing was printed in matte white PLA, to act as a good diffusor.
The inner part was printed using matte black PLA, which blocks light from the flash LED to reflect directly in the direction of the camera lens.

The holder was designed to fit on a Zehner branded watermeter.

I attached my original Fusion project, so you can adjust it for your own meter.

Tagi