Tacx Neo shim: solving the grinding!
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Having problems with your grining Tacx Neo (1 and 2) and even installing a third o-ring did not solve the issue? Print…
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 26
- Wydruki
- 0
- Wyświetlenia
- 903
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution — Noncommercial
Having problems with your grining Tacx Neo (1 and 2) and even installing a third o-ring did not solve the issue?
Print this, take a single o-ring of your already installed o-rings and put it on the axle facing the o-ring inwards.
One version is with tiny discs on the bottom to increase adhesion on the bed
printed my shim as following:
o just one piece
o PetG (PLA will not work as it gets warm inside!)
o 85% infill
o 0,2mm layer
Take care to not tighten the dropout screw too much: hand-tight will do the job too!
Category: Electronics