Tacx Neo shim: solving the grinding!
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Having problems with your grining Tacx Neo (1 and 2) and even installing a third o-ring did not solve the issue? Print…
- Rating
- 0 / 5
- Likes
- 2
- Downloads
- 26
- Makes
- 0
- Views
- 909
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Electronics
- License
- Creative Commons — Attribution — Noncommercial
Having problems with your grining Tacx Neo (1 and 2) and even installing a third o-ring did not solve the issue?
Print this, take a single o-ring of your already installed o-rings and put it on the axle facing the o-ring inwards.
One version is with tiny discs on the bottom to increase adhesion on the bed
printed my shim as following:
o just one piece
o PetG (PLA will not work as it gets warm inside!)
o 85% infill
o 0,2mm layer
Take care to not tighten the dropout screw too much: hand-tight will do the job too!
Category: Electronics