Shop-Vac 12S Cartridge Filter Cap
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A cap to hold a cartridge-style filter in place on the Shop-Vac 12S.
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 19
- Wydruki
- 0
- Wyświetlenia
- 116
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Tools
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
I have an old Shop-Vac 12S200A 5 gallon vacuum that I always ran with the foam sleeve style filter. This was not very good. The body of the vac said this vacuum could use cartridge-style filters (Shop-Vac U/X/W). In a bout of cheapness I bought the Harbor Freight equivalent filter which fit on the vac just fine. Unfortunately the Bauer cap to hold the filter in place did not have a way to connect to the Shop-Vac. Instead, I made my own.
This model consists of the main cap piece and a series of clips. The pieces are separate to reduce the amount of supports required and to allow the clips to be printed flat. You need to print 8 clips; the clips then slide into the dovetails on the side of the cap. I recommend printing the cap top-down (as oriented in the STL). This will require supports in the middle but they will leave the lip that holds down the filter clean.
I printed this in PETG; PLA/etc may be fine but I figure the extra flexibility of PETG make the clips less likely to break.