1 / 6
Enclosure box for GoPower GP-PWM-30-UL solar charge controller — zdjęcie 1
1 / 6

Enclosure box for GoPower GP-PWM-30-UL solar charge controller

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

This is a protective enclosure for the GoPower GP-PWM-30-UL solar charge controller when it is used as a portable unit.

Ocena
0 / 5
Polubienia
0
Pobrania
5
Wydruki
0
Wyświetlenia
54
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Noncommercial

This is a simple protective enclosure box for the GoPower GP-PWM-30-UL solar battery charging controller. I want to use the controller as portable unit with my portable solar panels to charge and maintain a variety of batteries, including lithium, AGM, and lead-acid. The GP-PWM-30-UL is designed for permanent panel mounting.

I made the box with PETG, but PLA is probably fine too. Settings in the PrusaSlicer include 0.15mm QUALITY, supports everywhere, 15% infill, no brim. I used Add Modifier to add a 10 x 10 x 30mm cylinder around each screw hole with Fill Density of 40% and Perimeters set to 6.

Wall thickness of the box is nominally 0.2". A 1.25" hole in one end accepts a rubber grommet for the wires to pass through. The four screw holes are 0.1" ID, and fit #6 x 3/8" self tapping screws nicely.

The 2-ft solar input cable is made with 10-gauge wire terminated to an Anderson SB50 connector. I connect this to a 25-ft 8-gauge extension cable that connects to my portable solar panels. The 5-ft charger output cable is made with 12-gauge wire terminated to Schumacher battery clamps. A fuse holder with a 20A fuse is added to the positive wire for overcurrent protection.

Tagi