Anet A8 Small Front Brace
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
There are many front frame braces over thingiverse, but all of them are attached to the laterar thread rods. I have my…
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 22
- Wydruki
- 0
- Wyświetlenia
- 187
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution
There are many front frame braces over thingiverse, but all of them are attached to the laterar thread rods. I have my Anet anchored to a base, so I didn't need a large front frame because I could anchor the frame to the base too whit a couple of screws, so I design this model.
The screw holes are made for 3mm wide screws. The length of them depend of the thickness of your base.
Print Settings
Printer:
Anet A8
Rafts:
No
Supports:
No
Resolution:
0.2mm
Infill:
25%
Notes:
I printed mine at 0.15mm layer height, but at 0.2mm will be just OK as well.
Category: 3D Printer Parts