1 / 2
Qidi Q2 Slim Poop Slide / Chute – Space Saver Remix
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A remix of the poop slide for the Qidi Q2 printer. The width has been reduced to fit in tight spaces behind the printer
- Ocena
- 0 / 5
- Polubienia
- 11
- Pobrania
- 211
- Wydruki
- 0
- Wyświetlenia
- 935
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
SzczegółyPliki (2)Wydruki i komentarze (Wydruki: 0) (Komentarze: 1)Remiksy (1)Kolekcje (40)Powiązane
Material: PLA or PETG (PETG is better if the chute is close to hot parts) Layer Height: 0.2 mm Infill: 15% is enough Supports: No supports needed if printed vertically (standing up) Walls: 2 or 3 perimeters
Installation Just slide it onto the rear purge outlet of the Qidi Q2. It uses the same mounting mechanism as the original design.