1 / 4
K1(MAX) cooling duct with stock fan for use of EBB42 Gen2 — zdjęcie 1
1 / 4

K1(MAX) cooling duct with stock fan for use of EBB42 Gen2

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Based on my remix of Eugênio Schirmers fan duct Ive made this mod for users of BTTs EBB42 Gen2.

Ocena
0 / 5
Polubienia
3
Pobrania
34
Wydruki
0
Wyświetlenia
333
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

If you don't want to reprint the carriage, you only need to cut off a small piece and itll fit on stock and BCJ linear carriage. The fans mounting hole is outside beside the EBB42 pcb and no plugs or pins need to cut. The offset is choosen that deep, that the fan is very close to the door when homing.

The cable inlet is for users of servo cutter, but you can use it as base for your own mod.

All heat inserts are standard M3x4x4

Tagi