WD My Passport 1TB Windows Folder Case

A Windows OS file folder looking case for the Western Digital 1TB My Passport External SSD.

VERSION 2 currently in development ;) 

I never like how the original casing looked like, and found no suitable casing for this model. 

Before opening up the original casing, I recommend printing the middle part first to be prepared to transfer the internals to its new location safely immediately. 

Transferring SSD internals:

For following operations, please be very careful! 

You can "easily" open the original case by prying apart the top and bottom with a utility knife. Once you have achieved a slight opening of a few mm, I recommend using an old credit card or anything in that genre to further open the casing along the sides. 

I would HIGHLY RECOMMEND looking at following reference image to avoid hitting the SSD. 

Image by Tweaktown.com

Next up, unscrewing the 2 screws holding the PCB and SSD in place gives you access to take out the internals. Be very careful not to damage any components during this transfer. 

Place the internals (including white heat pads) into the new casing by first sliding the USB-C connector into its slot followed by screwing the boards into place. Don't overtighten these! 

Additional parts:

• 4x M3x8 Countersink screws

• 4x M3 5x4mm Brass Inserts

Printed parts:

• Middle part: White PLA

• Outer parts: Yellow PLA (or any other color to your liking)

Recommended 0.15mm layer height for fillets.

Disclaimer:

Depending on your use with the SSD, the casing might get warm. In case of heavy data usage, using PETG or ABS is recommended! By using these files, I am not liable for any SSD damage from opening the original casing, transfer or heat.