2nd Gen Tacoma Phone Mount (Mag Safe)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A minimalist phone mount design based off the design from Dave K's "2013 Toyota Tacoma Cell Phone Mount".
- Ocena
- 0 / 5
- Polubienia
- 4
- Pobrania
- 31
- Wydruki
- 0
- Wyświetlenia
- 440
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Automotive
- Licencja
- Creative Commons — Attribution — Noncommercial
Created in PETG for additional temperature resistance and overall rigidity, this phone mount is designed to integrate minimally with the stock 2nd Gen Tacoma dash (near the climate control and under the stock stereo. This design is aimed to keep a phone with Mag Safe mounted at a fixed angle magnetically making it easy to take on and off which becoming bulky. In case the angle is unsatisfactory, there is a small angled connector piece that sits between the front plate and Mag Safe charger mount that can easily be redesigned to fit the desired angle. The following hardware is required:
2x M3 Nuts
6x M3 Washers (around 6mm diameter)
2x M3 x 12mm bolts
4x M3 x 8mm bolts
4x M3 x 6mm heat set inserts
1x command strip or adhesive (not required but makes it much easier to install)
Directions:
Install the 2x M3 Nuts to the back side of the back plate.
Install 2x heat set inserts to the outside front of the front plate.
Install 2x heat set inserts to the front of the angled block.
Apply command strip or adhesive to the back plate (opposite side of M3 nuts).
Align front plate to the mounting location and mark with a sharpie the location of the holes.
Drill out the holes marked in step 5.
Disassemble the dash/climate control area of your 2nd Gen Tacoma to gain access to the front and back of the mounting area. (Helpful video guide).
Hold the back plate on the inside of mounting location and align it will the holes using the M3 bolts as a guide.
Adhere the back plate to the inside of the mounting point (use just the M3 bolts to hold it in position while it sticks/dries.
Once dry remove any hardware and reassemble the dash/stereo of you Tacoma.
With everything back in place bolt the front plate to the mounting point pinching the mounting point with the backplate (M3 x 12mm bolts).
Bolt the angled block to the front plate (2x M3 x 6mm bolts).
Bolt the Mag Safe charger to the angled block (2x M3 x 6mm bolts).
Install the Mag Safe charger to the Mag Charger mount (press fit).