1 / 5
6384 Motor Mount for Axis 19mm Aluminum Mast - Foil Assist / Foil Drive - Zip Tie Version - V1 — zdjęcie 1
1 / 5

6384 Motor Mount for Axis 19mm Aluminum Mast - Foil Assist / Foil Drive - Zip Tie Version - V1

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

A motor mount for Flipsky 6384/6374 motors designed for DIY foil drive or foil assist. Includes STEP file.

Ocena
0 / 5
Polubienia
11
Pobrania
209
Wydruki
0
Wyświetlenia
1047
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution

**Updated model again - I updated the model so the mount is shorter (less swing weight), main change is I inverted the dove tail. 

*Updated model - The file title with "update" has a small change where I rounded off the leading edge of the mast because I found it could be a stress riser. It never broke on me while in use but it did crack. Printing the cone portion in 95A or 64D TPU is actually a really good option, I've switched to it after some real world stress testing. The motor mount should be printed in a rigid filament still.

I created a previous version of this motor mount that uses a 3D printed TPU strap. This version uses three zip ties and three zip tie heads. There is much less play in this version, as the TPU strap can stretch over time and can cause the pod to move slightly. I recommend using this version over my old version.

This is a minimalist motor mount (Flipsky 6384/6374 motor) for a DIY foil drive / foil assist. I modeled a mast mount insert for the red Axis 19mm mast. If you want to make your own mast mount insert, included is a blank motor mount that you can use to Boolean (subtract) your own foil mast but you'll have to model it yourself. 

To hold the rear mount to the pod, two 4mm screws are threaded into two 4mm hotmelt inserts that are 6mm deep x 6.75mm diameter. Find them on Aliexpress, Amazon, CNC Kitchen etc.

Uses 4mm x 15mm stainless steel bolts to mount the motor, bolt pattern is 30mm x 30mm.

I'd recommend printing the motor mount in a tough filament like PLA+, PETG, ASA, etc. Perimeters use 6 or more, the more you use the stronger it will be but the heavier the mount will be of course. 

I'd also recommend using some electrical tape on the mast to help make up any minor gaps and adds some extra friction for the pod to grab.

Use high-quality, UV-resistant zip ties. Install use one full zip tie and thread the tail into a second zip tie with the tail cut off to secure the pod in place. Do this three times. Here are the ones I use: https://amzn.to/45tbzaA

STEP files are included if you want to modify any of the files to work for you.

My model is inspired by this that came up on my feed: https://thee3shop.com/

Tagi