Customizable Ramekin Stacker
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Ramekin stacking rings: My ramekins wouldn't stack properly - the stack would tip when they got too high. These…
- Ocena
- 0 / 5
- Polubienia
- 3
- Pobrania
- 28
- Wydruki
- 0
- Wyświetlenia
- 266
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Kitchen
- Licencja
- Creative Commons — Attribution
Ramekin stacking rings: My ramekins wouldn't stack properly - the stack would tip when they got too high. These plastic rings are sized to give a firm base for the next one, with a ring ledge to keep them aligned.
To cut down on material and avoid needing support, print two of them, and glue them together.
Print Settings
Printer Brand:
Prusa
Printer:
i3 MK3
Rafts:
No
Supports:
No
Resolution:
0.2mm
Infill:
0%
Filament: Monoprice PLA Clear
Notes:
Print two. Glue together with cyanoacrylate glue. While gluing, use at least two pieces of scrap filament as alignment pins.
After looking at https://www.thingiverse.com/thing:4277881rnrnhis design grips the inner wall of the lower rameking but needs support to print. An OpenSCAD version of that would be:rnrn /outer diameter of ramekin /rn outerDia=85;rnrn /inner diameter of ramekin /rn innerDia=73;rnrn /wall thickness in the radial dimension /rn thickR=4;rnrn /wall thickness in the Z dimension /rn height=8;rnrn /ring connector thickness /rn floor=1.2;rnrn $fn=120;rnrn difference(){rn union(){rn translate([0, 0, height])cylinder(d=outerDia+thickR, h=height+floor);rn cylinder(d=innerDia, h=height+thickR);rn }rn translate([0, 0, height+floor])cylinder(d=outerDia, h=height+floor);rn translate([0, 0, -thickR])cylinder(d=innerDia-thickR, h=2*(height+thickR));rn }rnrn
Category: Kitchen & Dining