Case and mount for LD2450 and ESP32 C3 Super Mini
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
The case is designed to house a LD2450 and a ESP32 C3 Super mini module.
- Ocena
- 5 / 5
- Polubienia
- 26
- Pobrania
- 269
- Wydruki
- 1
- Wyświetlenia
- 1539
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution
The case is designed to house ESP32 C3 Super mini modules with OR without pins soldered to it. The lid has two variations: Plain and with radar symbol.
Features
Space for the ESP32 C3 super mini and HLK-LD2450 modules, bluetooth antenna and wiring
Hinged stand to allow modification of the angle the LD2450 is monitoring
Assembly
Stand
1 * m3x12 or longer bolt
1 * m3 nut
LD2450
Place the module into the lid using the small stubs. The side with with the JST ZH connector should have more space than the other side. The Hi-Link documentation tells me that the connector part should be up, but personally my zones worked better in testing the other way around, so check for yourself. You can just turn the lid 180 degrees.
ESP32 C3 Super Mini
If you have pins soldered on just reverse the module to get it in position. The cables attached should keep the module in place.
Printing instructions
Orientation: Check photos
Layer height: 0.2mm
Walls: 2
Infill: minimum of 10%. I did mine with 20% infill on the stand and the rest on 100%.
Supports: The overhang of the stand is 60%. I have no problem printing without supports but your milage may vary. In case of failures or if unsure I would try it with organic on buildplate only.
Attribution
- Lid Radar symbol: https://uxwing.com/radar-tracking-icon/