Soccer Blast Paraphernalia
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
For use with Soccer Blast from PLAAY Games
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 7
- Wydruki
- 0
- Wyświetlenia
- 310
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Board Games
- Licencja
- Creative Commons — Public Domain
You need to print the following models in the following quantities:
two-sided.stl (10, 5 in each color)
keeper.stl (2, 1 in each color)
clicker.stl (10)
rod_1.stl (2)
rod_2.stl (2)
side (6)
washer (10)
I print these in PLA with a 0.3mm layer height. None of the models need to be printed with supports. I recommend printing 5 two-sided.stl models and 1 keeper.stl model in one color and the other set in another color.
Print the strip.stl file with a layer height of 0.2mm or less. If your printer and slicer software support it, I recommend printing the strip in 2 colors. For example, print the top layer in white and the bottom layers in black. I also recommend setting your slicer to iron the top layer. It’s not required to fit the pieces together, but it looks much nicer.
- Insert a clicker onto each two-sided card holder. Each clicker should have the same alignment as the other clickers on its team. See the image below.
https://www.kjmagnetics.com/proddetail.asp?prod=D34 (sufficient)
https://www.kjmagnetics.com/proddetail.asp?prod=D34-N52 (slightly better)
- Insert magnets into the ends of all the rods such that the rod_1s are attracted to the rod_2s.
Watch the video on the my YouTube channel to see the suggested assembly steps.