Soccer Blast Paraphernalia
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
For use with Soccer Blast from PLAAY Games
- Rating
- 0 / 5
- Likes
- 0
- Downloads
- 7
- Makes
- 0
- Views
- 310
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Board Games
- License
- Creative Commons — Public Domain
You need to print the following models in the following quantities:
two-sided.stl (10, 5 in each color)
keeper.stl (2, 1 in each color)
clicker.stl (10)
rod_1.stl (2)
rod_2.stl (2)
side (6)
washer (10)
I print these in PLA with a 0.3mm layer height. None of the models need to be printed with supports. I recommend printing 5 two-sided.stl models and 1 keeper.stl model in one color and the other set in another color.
Print the strip.stl file with a layer height of 0.2mm or less. If your printer and slicer software support it, I recommend printing the strip in 2 colors. For example, print the top layer in white and the bottom layers in black. I also recommend setting your slicer to iron the top layer. It’s not required to fit the pieces together, but it looks much nicer.
- Insert a clicker onto each two-sided card holder. Each clicker should have the same alignment as the other clickers on its team. See the image below.
https://www.kjmagnetics.com/proddetail.asp?prod=D34 (sufficient)
https://www.kjmagnetics.com/proddetail.asp?prod=D34-N52 (slightly better)
- Insert magnets into the ends of all the rods such that the rod_1s are attracted to the rod_2s.
Watch the video on the my YouTube channel to see the suggested assembly steps.